Door Handles; Ash Box - Bullerjan 0042 Manual Del Usuario

A
B
C
D
1.1 Bullerjan hot air stoves
®
Required tools: screwdriver for slotted screws
Torsion spring (only type 00 & 01 available as equipment)
The use of the torsion spring is necessary if you connect the stove to
a joint chimney.
Install the door by aligning the holes of the door hinges with the
hinge flanges located on the right side of the door opening (A).
The door must rest on top of the stove flanges. Insert the door pin
through the top door hinge flange that you have aligned with the top
flange on the stove, then through the door spring and finally through
the bottom door hinge assembly as shown in (B). Lock the pin into
place using the snap ring supplied.

Door handles

Put the washer and the larger handle over the metal door latch
and fasten. Install the smaller wooden damper handle by turning it
counter-clockwise over the damper bolt. (C).

Ash box

Fasten the ash box on the bolts under the heater door as shown (D).
23