1. Completely remove the support bar. Place the support bar's anchor (D) back on its wall mark, then mark its center
on the wall.
2-3. Drill a hole on the center marks with a ø8mm (5/16in) drill bit and insert the wall anchors (FF) using a rubber
mallet. Fix the center fitting on the support bar's anchor (D) using the screws (HH).
4 Slide again the auxiliary roller (E), 2 fixed panel's brackets (G) and the support bar's anchor (D) onto the support bar
(F). Then fix the support bar to fixed panel (C) by the 2 fixed panel's brackets (G).
5. Fix the support bar's anchor (D) to wall.
1
D
3
D
HH
5
D
SUPPORT BAR INSTALLATION
FF
13
2
Φ 8mm
5/16in
4
G
KK
C