Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
–– FIRST PART ––
for the user and installer
1 - Recommendations regarding safety
(fig. A)
Only install the product in indoor or protected environ-
ments. Do not wet the product with liquid substances and
keep it away from steam and excessive humidity.
2 - Description of the product and
destination of use
WMS01S is a radio transmitter that allows to control the Nice
automations for shutters, sun screens and sun awnings, in
manual mode or in automatic mode.
The main purpose of the product is to be used in automat-
ic mode, to control the comfort of the indoor environment
through opening and closing of the sun screens, protecting
it from excessive sunlight.
In order to function in automatic mode, the product makes
use of light sensors, one rear and one front, which allow to
control the sun screens depending on the intensity of the
sunlight.
The rear sensor only allows to control the shutters on the
window where the transmitter is installed.
However, the front sensor allows to control various types of
sun screens such as shutters, sun awnings and similar. In
this case, the transmitter must be installed inside the envi-
ronment to be protected, in a position where it can perceive
the effects of the greater or lesser sun screening, without
however being hit directly by the light coming from outdoors.
All other use is prohibited! The manufacturer declines all
responsibility for damage/injury caused to objects/per-
sons deriving from improper use of the product, differ-
ent to that described in this manual.
2.1 - Parts of the product (fig. 1)
1) - Data display.
2) - Keys with various functions (see chapter 5).
3) - Front light sensor.
4) - Rear light sensor.
5) - Battery compartment.
3 - Display switch-on/off
The display switches-on by pressing any key and switch-
es-off automatically after 30 seconds from when the last
key is pressed.
4 - The product screens
4.1 - The user screen (fig. 2)
On display switch-on, the user screen appears, made up
from the following elements:
a) "Intensity" Bar: shows the intensity of the light cap-
tured by the sensor.
b) Minimum light value (total darkness).
c) Maximum light value (blinding sun).
d) Light intensity value measured in real time.
e) "Light set" Bar: shows the points in which the interven-
tion thresholds are positioned and the amplitude of the
hysteresis area.
f) UPPER threshold (corresponds to the right end of the cur-
sor): when the light intensity increases and exceeds this
threshold, the system automatically controls the move-
ment of the sun screen with the purpose of decreasing the
light in the environment.
g) LOWER threshold (corresponds to the left end of the
cursor): when the light intensity decreases and exceeds
this threshold, the system automatically controls the
movement of the sun screen with the purpose of
increasing the light in the environment.
h) Minimum and maximum limit (not visible) within which it
is possible to shift the cursor-thresholds.
i) hysteresis area: it is the space between the two thres -
holds.
l)
Symbol: appears when the battery is running out.
m)
Symbol: appears when access to the programming
environment is blocked.
n)
Symbol: appears when the transmitter is in "Manual
pause".
o)
Symbol: appears when the transmitter is in "Timed
pause".
4.2 - The programming screens
The programming environment is formed by several screens.
To access the first screen, with the display on, hold the ° key
down until the icons appear and then release the key. To
operate in the programming environment, refer to chapter 10.
1
1
4
2
3
2
a
d
o
b
e
h
g
i
f
5
n m
l
c
h
English – 1
Publicidad
Tabla de contenido
