Correcting The Date And Time; * Quartzdate Models Only; Printing The Date/Time - Olympus IS-50 Manual De Instrucciones

24

CORRECTING THE DATE AND TIME

Be sure to correct the date and time after the batteries have been inserted or
replaced.
To set the "year" indicator:
1
1
Keep the MODE button pressed until the
"year" indicator starts blinking.
2
2
Press the SET button to adjust the "year"
indicator. If you press the button once, the
number on the display will advance by 1. If you
keep the button pressed, the numbers will run in
rapid succession. If you pass the intended
number, keep pressing to return to that number.
To set the "month" indicator:
3
3
Press the MODE button once more to
make the "month" indicator blink. Press
the SET button to adjust the "month"
indicator.
4
As you press the MODE button, the blinking
indicator changes in the order of "year",
"month", "day", "hour" and "minute".
4
Repeat Steps
and "minute".
5
5
When "minute" has been set, press the
MODE button. None of the indicators will
be blinking and date/time correction is
now complete.

* Quartzdate models only

2 3
and to set "hour"

PRINTING THE DATE/TIME

First select the date/time mode you want to print.
Press the MODE button. As you press it,
the mode will switch in the order shown
below.
Keep the mode you want to print
displayed.
None
Year -month -day
Month -day -year
Day -month -year
Day -hour -minute
The date unit uses the same power source as the main unit. Be sure to
correct the date and time after the batteries are replaced.
The date/time is imprinted in the lower right corner of the picture. If the
date/time is superimposed on a bright color like white, orange, yellow, etc., it
may be difficult to read.
The date/time may not be imprinted correctly on the frame(s) after the
specified final exposure of the film.
When black-and-white film is used, the date/time may not be printed.
25
* Quartzdate models only