Operation; Quick Reference Guide; Basic Operation; Bluetooth Operation - Furrion DV3350 Manual De Instrucciones

Operation

Quick Reference Guide

Power on/off, switch to
standby mode
Mute
Select a source
Adjust volume
Select a feature / setting
Select a preset EQ
Set clock
Set alarm
Turn alarm on/off
Adjust brightness
Select speakers
Reset
Accept or make a call
Reject or end a call
15

Basic Operation

Press on the front panel to turn the unit on or enter standby mode.
Press and hold to turn the unit off.
Press on the front panel to mute the sound. The icon
Press again to restore the sound.
Press DISC/USB, AM/FM, AUX, or BT on the front panel to select Disc (with a disc loaded),
USB (with a USB storage device connected), Tuner, AUX or Bluetooth mode.
Rotate the VOLUME -/+ knob on the front panel to adjust the volume.
Press SEL on the front panel once or more to select VOL, BAS (without EQ preset), TRE
EQ
(without EQ preset), BAL, LOUD ON/OFF, LOC ON/OFF, ST ON/OFF, BEEP ON/OFF, SUB
ON/OFF, or CLOCK.
Then rotate the VOLUME -/+ knob on the front panel to select a feature / setting.
Press and hold SEL on the front panel once or more to select CINEMA, ROCK,CLASSIC,
EQ
FLAT, or EQ OFF.
Press CLOCK on the remote control to display the clock on the LCD.
Press SEL on the front panel once or more to enter clock setup mode.
EQ
/
Press on the front panel to switch between hour and minute setting.
Rotate the VOLUME -/+ knob on the front panel to adjust the hour/minute.
The time on the clock is set automatically after a few seconds of inactivity.
Press and hold on the front panel once or more to enter ALARM CLOCK and ALARM
SOURCE settings.
Repeat the operations in clock setting to set the alarm.
Two alarm sources are available for selection: TUNER and USB.
Press on the front panel to turn on or off the set alarm.
When the alarm is set, the icon
Press on the front panel once or more to select a brightness level for LCD screen:
LOW, MIDDLE or HIGH.
Press and hold ZONE 1 / ZONE 2 on the front panel to select speaker output.
The corresponding zone number will be displayed on the LCD once selected.
Press RESET on the front panel with a pointed object to reset the unit to factory default
settings.

Bluetooth Operation

Press to accept an incoming call, or dial or redial a telephone number.
Press to reject or end a call.
will display on the LCD.
flashes on the LCD.