Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Pair your remote
When you connect your fan to the network for the first 30 seconds, a pairing
channel is opened.
To pair your fan, press and hold the power button for 5 seconds in the 30 second
period.
The fan responds with a long beep. To pair multiple fans with the same remote
control, repeat the operation with each fan. Your fan is now paired.
OPERATION
1) On / Off: Press to switch on/off the fan.
2) Natural wind: Press once to turn on natural wind function. Press again to turn
off.
3) Speed: Press a speed button, the fan turns on in the selectd speed.
4) Timer
*
: Press to select the operating time until it turns off (0.30 h, 1h, 2h, 4h,
8h).
WiFi
*
: Press the timer button for 5 seconds to enter the WiFi function, the fan will
beep continuously until the device is in the network (see the "WiFi APP" section for
configuration).
5) Light On / Light Off
6) Dimmer
*
: Press + or - to change the intensity of the light.
FAVORITE LIGHT OPTION
5 seconds to save the selected colour or light tone, it will be recorded in the fan
memory. Next time light is switched on, it will be with the colour/tone and/or
intensity saved in memory.
5) or 7) Selection of colors of the light
KV) depending on the model.
8) Bip On / Off: Press the button for 5 seconds so that the fan stops beeping.
9) Temperature
*
The control receiver has a thermostat to automate the change of speed according
to the temperature under the fan.
Press the temperature button to switch the fan to temperature mode.
In this pre-programmed mode, your fan will react as follows:
Temperature
Speed
In winter mode, it has the same operation but the blades turn in the opposite
direction.
*
Depending on the model
*
: Press to turn on / off the light.
*
(RGB or tone and dimmer): Press the "
:
0 ~ 19°
19° ~ 21°
1
2
*
: RGB mode or Tone (3000/4000/6000
22° ~ 24° 25° ~ 26° 27 ~ 28°
3
4
10
+
" button for
+29°
5
6
Publicidad
Tabla de contenido
