After Use; Removing The Head; Maintenance; Warranty Conditions - Lavor ETNA 3000 Manual De Usuario

2. the no-water level pilot light C flashes
3. the steam stops coming out
To top up, proceed as follows:
• Switch off the boiler switch E
• Turn off the main switch B
• Remove the cable from the socket
• Fill the boiler water tank J

AFTER USE

• Every time you finish working, put switch B, E
and P in OFF position.
• Extract the plug from the wall socket.

REMOVING THE HEAD

• Before taking the head A off of the drum I,
remove the prove K from the tank (fig. 7)
- Release the hooks G and raise the head A
(Fig. 8 and 9).
- Put the washable filter on the head (Fig. 10
and 11).
- Put the head A on the drum I, put the
prove in the correct hole K and close with
hooks.

MAINTENANCE

• Steam nozzle
- Clean periodically, with the clean pin's
equipment, the nozzle inside the outlet
plug for steam H
• Washable filter
- Wash it with running water, from the in-
side to the outside of the filter. Keep it dry
before re-assembling it.
• Air filter
- Clean the air filter M situated at the right
side of the machine every day, removing
dirt using compressed air.
• Accessories
- When using the appliance with combined
functions, i.e. steam and vacuum clean-
ing, wet dirt can jam and stuck inside the
pipes of flexible hose, extension tubes and
18
.
2
accessories. This dirt may generate bad
odours, can make the fitting of the acces-
sories very difficult and could reduce the
performance of the appliance. To elimi-
nate dirty residues from the inside of the
attachments (extension tubes or brushes),
wash the vacuum ducts with running wa-
ter, and remove any residues.
- Warning! Do not wash or immerge the flex
in water or any other liquid. For a thour-
ough cleaning of the flex empty the tank,
fit the extension + sprayer attachment and
suck one liter of fresh water through the
flex into the tank.
- Periodically check if the seals worn out
and, if necessary, replace them.

WARRANTY CONDITIONS

All our machines are subjected to strict tests
and are covered against manufacturing de-
fects in accordance with applicable regulations
(minimum 12 months). The warranty is effec-
tive from the date of purchase. If your device or
accessories are handed in for repair, a copy of
the receipt must be enclosed. During the guar-
antee period our assistance centre will repair
all those malfunctions that, despite the user
has followed the instructions in our manual,
can be put down to defective materials. The
parts deemed faulty will either be replaced or
repaired under the guarantee. The replaced
parts remain our property. Replacements or
repairs do not extend the guarantee period;
for the parts replaced, the appliance's period
of guarantee is valid. We are not held responsi-
ble for damages or faults to the appliance or to
any of its components if they are caused by an
improper use or maintenance of the appliance.
The same applies if the instructions given in
our handbook are not followed or if parts or ac-
cessories are used that are not included in our
programme. The guarantee will no longer be
considered valid if people that have not been
authorised by to us tamper with the appliance.
EN