Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2. Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your hair,
clothing, and gloves away from moving parts.
caught in moving parts
3. Avoid accidental starting. Be sure switch is in the locked or off position before inserting
battery pack. Carrying tools with your finger on the switch or inserting the battery pack into a
tool with the switch on invites accidents.
4. Remove adjusting keys or wrenches before turning the tool on. A wrench or a key that is
left attached to a rotating part of the tool may result in personal injury.
5. Do not overreach. Keep proper footing and balance at all times. Proper footing and
balance enable better control of the tool in unexpected Situations.
6. Use safety equipment. Always wear eye protection. Dust mask, non-skid safety shoes,
hard hat, or hearing protection must be used for appropriate conditions.
7. Do not wear loose clothing or jewelry. Contain lang hair. Loose clothes, jewelry, or lang
hair can be drawn into air vents.
8. Do not use on a ladder or unstable support. Stable footing on a solid surface enables
better control of the tool in unexpected situations.
TOOL USE AND CARE
1.
Use clamps or other practical way to secure and support the workpiece to a stable
platform. Holding the work by hand or against your body is unstable and may lead to
lass of control.
2.
Do not force tool. Use the correct tool for your application. The correct tool will do the
job better and safer at the rate for which it is designed.
3.
Do not use tool if switch does not turn it on or off. A tool that cannot be controlled with
the switch is dangerous and must be repaired.
4.
Disconnect battery pack from tool or place the switch in the locked or off position before
making any adjustments, changing accessories, or storing the tool.
safety measures reduce the risk of starting the tool accidentally.
Loose clothes, jewelry, or long hair can be
Such preventive
4
to disconnect the power supply. lf this occurs, switch off the tool and switch on again to
resume the work, make sure to apply only suitable workload to the tool. When the tool
works under heavy load for a long period of time, the temperature of the tool or battery
pack will increase significantly. The protection device will be activated at a preset
temperature to protect both the tool and the battery. lf this occurs, switch off the tool and
wait until it cools down to ambient temperature and resume work.
Note: when the voltage of battery pack is dropped to 7.5V, the protection device will also be
activated. In this case, remove the battery pack and fully charge it before reuse.
ADDIITIONAL PRECAUTIONS FOR CHARGER & BATTERY PACK
1.
Do not charge battery pack when temperature is below 1
°
(104
F).
2.
Oo not attempt to use a step-up transformer, an engine generator or DC power
receptacle.
Do not allow anything to cover or clog the charger vents.
3.
4.
Always protect the battery terminals when the battery pack is not used.
5.
Do not short the battery pack.
6.
Do not tauch the terminals with any conductive material.
7.
Avoid storing battery cartridge in a container with other metal objectssuch as nails,
coins, etc.
8.
Do not expose battery pack to water or rain.
Warning!
A battery short can cause a large current flow, overheating, possible bums and even a
breakdown.
9. Do not store the tool and Battery pack in locations where the temperature may reach or
°
exceed 50
C (122
°
F).
10. Do not incinerate the Battery pack even if it is severely damaged or is completely
worn out.
Thebattery pack can explode in a fire.
o·c
°
°
(50
F) or above 40
13
C
Publicidad
Tabla de contenido
