Uriflex Contessa Instrucciones página 13

HOW TO USE THE CONTESSA
BEDWETTING ALARM
To switch on
Plug the connector into both the alarm (see photo) and into a plug socket.
On top of the alarm on the left a small light lights up continuously.
Transmitter
The transmitter includes a 3V-battery. This battery works for at least 2
months in situations of normal use.
Before use, all the transmitter press buttons should be snapped onto the
front of the sensor briefs (see photo).
transmitter by connecting the two push buttons on the transmitter using a
metal object - for example a pair of scissors. But make sure that the receiver
is on. If the alarm doesn't start and the error indicator on the bottom of the
receiver doesn't light up, the battery should be replaced.
Replacing the transmitter battery
Open the transmitter using a fl at screwdriver to carefully disconnect the top
and bottom part of the transmitter box. Place the screwdriver in the middle
of one of the two short sides. Gently remove the present battery from un-
derneath the clamp. Insert a new battery the same way and gently press the
clamp. Make sure that the rubber O-rings are placed correctly (thin below
and thick above) and shut the transmitter.
Battery type
The transmitter is powered by a 3V battery type CR2032. We prefer the
brand Varta. Most important is that the bottom of the battery is smooth and
has as little structure as possible.
13
WWW.URIFLEX.COM URIFOON
>> Always remove the transmitter from the sensor
briefs when the bedwetting alarm isn't being used.
This will spare the battery! Replace the battery of
the transmitter when the low battery indicator on
the bottom of the receiver lights up.
You can always check the proper functioning of the
WWW.URIFLEX.COM