Noise Information; Vibration Information; Assembly & Operation - Worx WG252E Manual Original

Input: 100-240V
~ 50/60Hz,
Charger rating
Output: 20V
Charging time
58 mins
(approx.)
Machine Weight
*Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.

NOISE INFORMATION

A weighted sound pressure
A weighted sound power
Wear ear protection

VIBRATION INFORMATION

Vibration total values (triax vector sum)
determined according to EN 60745:
Vibration emission value: a
Uncertainty K = 1.5m/s²
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
20V Cordless Pole Hedge Trimmer
/
, 2.0A
/
3.6kg 3.2kg
L = 79 dB(A)
pA
K = 3 dB(A)
pA
L =89.2 dB(A)
wA
K = 3 dB(A)
wA
= 2.56 m/s
2
h
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORIES
Battery pack (WA3551)
Charger (WA3880)
Blade sheath
Shoulder strap
Hedge trimmer
attachment (WA0308)
We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the tool. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for cutting and trimming
hedges and bushes in domestic use.
ASSEMBLY & OPERATION
ACTION
BEFORE OPERATION
Installing the battery pack
Removing the battery pack
Checking the battery condition
NOTE: Fig. A3 only applies for the
battery pack with the battery indicator
light.
WG252E WG252E.9
1 /
1 /
1
1
1
FIGURE
See Fig.A1
See Fig.A2
See Fig.A3
EN
11