Controls; Description Of Control Panel - ELICA Space Manual De Instrucciones

Controls

Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.

Description of control panel

1. Lights ON/OFF Key: press and release to turn the lights
on and off at the preset intensity; keep pressed to adjust
the intensity of the light.
2. ON(Stand by)/OFF suction Key
-ON (Stand by) – the Key is on.
-OFF - the Key is off: all the commands with the
exception of key 1 are disenabled.
To set the hood on ON (stand by) or OFF press the key
and wait until the key lights up or turns off on the basis of
the setting desired.
3. Speed (power) suction selection key 1: press once to
select the suction speed (power), press again and keep
it pressed to activate 20 minute (flashing key) functioning
time, after which the hood turns off (Stand by)
4. Speed (power) suction selection key 2: press once to
select the suction speed (power), press again and keep
it pressed to activate 15 minute (flashing key) functioning
time, after which the hood turns off (Stand by)
5. Speed (power) suction selection key 3: press once to
select the suction speed (power), press again and keep
it pressed to activate 10 minute (flashing key) functioning
time, after which the hood turns off (Stand by).
6. Intensive suction speed (power) ON/OFF selection
key (timed): press to select the suction speed (power).
Functioning time is 5 minutes after which suction turns
off or returns to the speed (power) previously selected.
7. COMFORT button: the hood begins to operate in a
"cyclical" manner when filtering the air, which means the
motor is activated at speed level 1 for 5 minutes and
then switched OFF for 30 minutes. This operating mode
remains set until the OFF button (or any of the speed
buttons) is pressed; this will stop the COMFORT function
and activate the motor at the selected speed level.
8. Reset saturation filters key: the hood, through the
signal of this luminous key, tells the user when it is
necessary to carry out maintenance of the fat filters and
the carbon filter.
Key lit in green: carry out maintenance of the fat filters,
after which press the key for about 3 seconds and the
key turns off.
Key lit in red: carry out maintenance of the carbon filter,
after which press the key for about 3 seconds and the
key turns off.
Attention: the hood is preset only for signaling the fat
filters.
To enable the signaling of the carbon filter: Set the
hood on OFF, press key 8 for 3 seconds. The key turns
on in red to signal that the setting has taken place. To
disenable the carbon filter signal, repeat this operation
again (the key lights up in green).
Note: A beep sounds each time this key is pressed.
15