Performance Data Sheet - Watts PURE WATER PWDWLCV2 Manual Del Usuario

GENERAL USE CONDITIONS:
1: System to be used with municipal or well water sources treated and tested on regular basis to insure bacteriological safe quality. DO
NOT use with water that is micro biologically unsafe or of unknown quality without adequate disinfection before or after the system.
Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.
2: Operating Temperature:
3: Operating Water Pressure:
4: Maximum flow Rate:
5: Rated Capacity:
RECOMMENDED REPLACEMENT PARTS AND CHANGE INTERVAL:
Note: Depending on incoming feed water conditions replacement time frame may vary.
Description
Stage 1: Sediment filter
Stage 2: Lead, Cyst, VOC Carbon block
This system has been tested according to NSF/ANSI Standard 53 for the reduction of the substances listed below. The concentration
of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for
water leaving the system, as specified in NSF/ANSI 53. Testing performed under standard laboratory conditions, actual performance
may vary.
Substance
ALACHLOR*
ATRAZINE*
BENZENE*
BROMODICHLOROMETHANE (TTHM)*
BROMOFORM (TTHM)*
CARBOFURAN (Furadan)*
CARBON TETRACHLORIDE*
CHLORDANE
CHLOROBENZENE (Monochlorobenzene)*
CHLOROFORM (TTHM)*
CRYPTOSPORIDIUM (see Cyst)
CYST
CHLOROPICRIN
2, 4-D*
DBCP (see Dibromochloropropane)*
1,2-DCA (see 1,2-DICHLOROETHANE)*
1,1-DCE (see 1,1-DICHLOROETHYLENE)*
DIBROMOCHLOROMETHANE
(TTHM;Chlorodibromomethane)*
DIBROMOCHLOROPROPANE (DBCP)*
o-DICHLOROBENZENE (1,2 Dichlorobenzene)*
p-DICHLOROBENZENE (para-Dichlorobenzene)*
1,2-DICHLOROETHANE (1,2-DCA)*
1,1-DICHLOROETHYLENE (1,1-DCE)*
CIS-1,2-DICHLOROETHYLENE*
TRANS-1,2- DICHLOROETHYLENE*
1,2-DICHLOROPROPANE (Propylene Dichloride)*
CIS-1,3- DICHLOROPROPYLENE*
DINOSEB*
EDB (see ETHYLENE DIBROMIDE)*
ENDRIN*

Performance Data Sheet

PWDWLCV2
Watts Pure Water
8716 W Ludlow Drive Suite #1
Peoria, AZ 85381
1-(800)-224-1299
Maximum 100 F (37.8
o
Maximum 85psi (5.98 kg/cm
0.50 gpm (1.89 lpm)
600 Gallons (2,200 liters)
Part Number
7100331
7100451
Percent
Reduction
>99.8%
>99.8%
>99.8%
99.99%
99.99%
>99.8%
8
C) Minimum 40
o
) Minimum 20psi (1.406 kg/cm²)
2
Change time Frame
6 Months or 600 gallons of water
6 Months or 600 gallons of water
Influent Challenge
Concentration
(mg/L unless noted)
>98% 0.050
>97% 0.100
>99% 0.081
0.300 +/- 0.30
0.300 +/- 0.30
>99% 0.190
98% 0.078
0.04 +/- 0.10
>99% 0.077
0.300 +/- 0.30
minimum 50,000/mL
minimum 50,000/mL
0.015
98% 0.110
>99% 0.052
95% 0.088
>99% 0.083
0.052
>99% 0.004 +/- 0.10
>99% 0.080
>98% 0.040
95% 0.088
>99% 0.083
>99% 0.170
>99% 0.086
>99% 0.080
>99% 0.079
99% 0.170
>99% 0.044
99% 0.006 +/- 0.10
F (4.4 C)
o o
Maximum Permissible
Product Water
Concentration
0.001
0.003
0.001
0.015
0.015
0.001
0.0018
0.002
0.001
0.015
99.95%
99.95%
0.0002
0.0017
0.00002
0.0048
0.001
0.00002
0.0002
0.001
0.001
0.0048
0.001
0.0005
0.001
0.001
0.001
0.0002
0.00002
0.002