Winter Storage - Xylem Jabsco 38110 Manual Del Usuario

• 1x1" Overboard discharge port macerator pump out. Discharge:
connect to the overboard discharge thru-hull fitting.
*See plumbing diagram for recommended installation.
Electrical:
Wire the unit in an Independent Circuit.
Consult the wiring table for fuse and wire size.
Consult the wiring diagram for connections.
Wiring Table
AMP FUSE
VOLTAGE DRAW SIZE
12 Vdc 16
24Vdc 8
* Length of run is total length of the circuit from the power source to
product and back to ground. Wire sizes listed are AWG gauge and
metric millimeters.
Maintenance:
Flush system with clean water to remove any build up of sludge or
debris. It is recommended that this process be completed at least
once a year. Please reference 18590 Series Macerator datasheet
servicing section for details.

Winter storage:

Empty the complete system of all water making sure pipe work and
pump are completely free of waste.
KEY
1 Battery
2 Fuse
3 Waste Management System
4 Master Switch
5 Controller for Waste Management System
KEY
1 Vent
2 Inlet
3 Toilet
4 Deck
5 Pumpout
6 Waste Holding Tank
7 Vertical Loop Outlet
KEY
1 1-1/2" Barbed Pick-Up tube
2 1-1/2" Barbed Inlet Port
3 Vent 3/4"
Vent 5/8"
4 Cap and O-Ring
5 Tank
6 Kick Panel
7 Control Box on Tank
8 Sensor Array
9 Macerator 12v
Macerator 24v
15 Foot Control Cable
20 Foot Control Cable
30 Foot Control Cable
10 Control Panel 12v
10 Control Panel 24v
WIRE SIZE PER FEET OF RUN*
0"-10" 10"-15" 15"-25" 25"-40" 40"-60"
20 #16(1.5) #14(2.5) #14(2.5) #12(4) #6(16)
15 #18(1) #16(1.5) #16(1.5) #14(2.5) #10(6)
DESCRIPTION
DESCRIPTION
DESCRIPTION
(Sensors under Kick Panel)
KIT PART NUMBER
38111-0000
38111-0010
38112-0000
38112-0010
38115-0000
38113-0000
38114-0000
38116-0000
38117-0000
18590-2092
18590-2094
47010-0000
47020-0000
47030-0000
38111-0012
38111-0024