Sea gull lighting AMBIANCE 94458 Manual Del Usuario página 3

1C
X2
9
Install a conduit connector and bring the low-voltage
7
connector wires from the fixture to the remote
transformer.
For the best performance, use the "Low Voltage Wire
8
NOTE:
Other wire sizes that comply with electrical
code can be used, but may result in an increased
voltage drop and reduced lamp intensity.
NOTE:
The THHN wire sizes are for 3% or less drop
in voltage based on 75 watt loads. Lengths are the
distance from the transformer to the system power
feed connector.
9
Connect one low voltage wire to the transformer wire
marked "X1" with a wire nut.
Connect the second low voltage wire to the transformer
10
wire marked "X2" with a wire nut.
120V
COM
BOOST
10
Check the System
2A
X2
10
3
PHILLIPS
SCREW
CIRCUIT BREAKER
After installing the entire system, operate the system for
1
five minutes.
2
The transformer circuit breaker will trip if there is a short
in the system. After removing the cause of the short, the
circuit breaker needs to be reset to power the system
up.
Replace the transformer cover and tighten the two
3
Phillips screws on the sides of the transformer.
3
120V
COM
BOOST
11
2
3