Steelman MagicLif JS647530 Manual De Piezas E Instrucciones De Funcionamiento página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
Lifting
!
Only attachments and/or adapters supplied by the manufacturer shall be used. Lift only on area of the
vehicle as specified by the vehicle manufacturer.
1. Follow the vehicle manufacturer's recommended guidelines for lifting. Engage the emergency brake and chock each unlifted
wheel in both directions to prevent inadvertent vehicle movement.
2. Close the release valve by turning the handle clockwise until firm resistance is felt.
3. Refer to the vehicle manufacturer owner's manual to locate approved lifting points on the vehicle. Center jack saddle under
lift point.
4. Verify lift point, pump handle to contact lift point. To lift, pump handle until load reaches desired height.
5. Transfer the load immediately to appropriately rated jack stands.
NEVER use hydraulic jack as a stand alone device! ALWAYS transfer the lifted load IMMEDIATELY to a
!
pair of appropriately rated jack stands. Use one pair of jack stands per vehicle. Rated capacity is per pair
only! Do not exceed rated capacity.
Lowering
Be sure all tools and personnel are clear before lowering load. Slowly open the release valve! The more
!
you turn the handle counter-clockwise, the faster the load will come down. Maintain control of the rate of speed at
which the load lowers at all times!
1. Raise load high enough to clear the jack stands.
2. Remove jack stands carefully.
3. Slowly turn the handle counter-clockwise, but no more than 1/2 full turn. If the load fails to lower:
a. Use another jack to raise the vehicle high enough to reinstall jack stands.
b. Remove the malfunctioning jack and then the jack stands.
c. Use the functioning jack to lower the vehicle.
4. After removing jack from under the vehicle, fully lower the saddle to reduce ram exposure to rust and contamination.
Oil Filler Plug
(refer to parts list for location)
Saddle
Front Wheel
Caster
Figure 1 - Typical Jack Nomenclature
Lifting Arm
Handle Fork
3
Handle
(release valve)
Foam Handle Pad

Publicidad

Tabla de contenido
loading

Tabla de contenido