Pioneer LAN Guia De Inicio Rapido página 14

5
Check that on the top of the unit, the POWER and the LAN lamps light
and WLAN lamp flashes.
When the lamp lights, wait for about 2 minutes and then proceed to the next step.
Lit
Flashes
Lit
6
Check that the network function of the connected AV receiver is
working properly.
For details, refer to the instruction manual of the AV receiver.
Setup is now completed.
Note
If you use the AV receiver's iControlAV, set the Network Standby setting of the AV receiver to
on according to the Operating Instructions of the AV receiver. In that case, even when the
AV receiver is in standby status, power is supplied to the wireless LAN converter.
14
Connecting to the AV Receiver (continued)
Troubleshooting
This section discusses issues that occur when setting up the unit and offers possible solutions.
The power is not turned on
Check that the unit and AV receiver are properly connected using the USB feeder cable.
Unable to connect to the Internet
Refer to "STEP 3 Connecting to the AV receiver" (page 13) to check that devices and cables
are connected properly.
Try turning the unit off and then back on.
If there is a significant distance or obstacles between the unit and the wireless LAN router,
bring the unit closer to the wireless LAN router at a place with no obstacle and then try
searching again.
There is a possibility that wireless communication is disturbed by electromagnetic waves
produced by a microwave oven. Connect the wireless device away from a microwave oven.
When the channel of the wireless LAN of the wireless LAN router is 12 or 13, change it to a
value between 1 and 11.
Check the setting content of the IP address on the AV receiver side (automatically acquired
setting or fixed setting). If it is a fixed setting, you need to set the unit so the IP address
matches the network on the wireless LAN router side.
For example, when the IP address of the wireless LAN router side is 192.168.1.1, set the IP
address of the AV receiver side to 192.168.1.XXX*, set the subnet mask to 255.255.255.0, and
set the gateway and DNS to 192.168.1.1.
*In XXX in 192.168.1.XXX, set a unique value that is different from other devices.
If the problem persists even after making the above changes, initialize the unit by referring
to the "Initialization" section (page 16).
It may take 2 to 5 minutes to connect to the Internet after the AV receiver is connected. If an
Internet connection is not established even after waiting for more than 5 minutes, perform
the setting again.