Lenco DAR-030 Manual Del Usuario página 9

13. Scan button
14. Alarm button
15. Back button
16. Sleep button
17. Stereo/Mono button
18. Dimmer button
19. Preset number buttons
20. Info button
21. Menu button
Initial use
Before operation, please make sure that the VOLTAGE mentioned on the power supply is same as
the voltage of your local area.
Use the supplied mains adaptor to connect the device to a household mains socket.
Switch the device on with the power switch on the rear.
Basic operation-getting started
Basic operation-getting started
1. Connect the mains adaptor to the micro USB jack, fully extend the telescopic antenna, plug in
and switch on at the mains.
2. The display backlight will illuminate and the clock (00:00:00) (Time is not set) will flash
3. On the very first use The DAB mode will automatically be selected and the radio will perform a
full scan. The display will show 'Scanning' with a bar indicator showing the scan progress and
the total number of stations found.
4. When the scan is finished the radio will play the first alphanumerically found station. If the
radio does not find any stations, 'No DAB Station' will be displayed.
5. Adjust the volume to the desired level using the VOL(+/-) knob.
6. Press the stations button and use knob to scroll through the stations list. Press the OK knob on
your favorite station.
7. Press the Mode button to switch between DAB, FM, Bluetooth and Aux input mode,
Press and hold the Standby button to go into 'Standby' mode.
8.
9