How To Connect/Remove External Dust Extraction; Operation; Switching On/Off; Practical Tips - Parkside PMS 160 A1 Traducción Del Manual De Instrucciones Original

GB MT
Emptying the dust collection box:
6. Push the tab (9) on the dust collection
box (8) and remove the dust collection
box lid (7).
7 To empty, simply shake or knock out
the dust collection box (8).
8. Then close the dust collection box (8)
again.
Empty the dust collection box regu-
larly to ensure optimal suction.
How to connect/remove
external dust extraction
Connecting external dust extraction
1. Push the external dust extraction adap-
tor (10) as far as it will go on the dust
extraction connector (4).
A suitable vacuum cleaner must
be used (e.g. a workshop vacuum
cleaner). Normal household vac-
uum cleaners are not intended for
vacuuming sanding material. This
information can be found in the op-
erating instructions of the external
device.
2. Connect the extraction hose from a
vacuum cleaner (sold separately) to the
external dust extraction adaptor (10).
Make sure that the dust extraction sys-
tem is suitable for the material to be cut.
Removing external dust extraction
1. Remove the extraction hose from the
external dust extraction adaptor (10).
2. Disconnect the adapter for external
dust extraction (10).
If necessary, you can connect the
suction tube of a vacuum cleaner
directly to the device without an
adapter.
56

Operation

Switching on/off

Make sure that the power supply
voltage matches the voltage rating
indicated on the device's type plate.
Connect the machine to the power
supply.
1. To switch on, flick the on/off switch (1)
to position „I". The tool will power on.
2. To switch off, flick the on/off switch (1)
to position „0". The tool will power off.

Practical tips

When working with the ap-
pliance, always wear suita-
ble clothing and appropriate
protective equipment.
Prior to each use it must be
ensured that the appliance is
working correctly.
Personal protective equip-
ment and a fully functional
appliance reduce the risk of
injuries and accidents.
Do not use the device without a
dust collection box or external dust
extraction. Use of a dust extraction
can reduce hazards caused by
dust.
When using sanding sheets without
ventilation holes, dust extraction
is not possible. Make sure that the
workplace is well ventilated.
Pull the mains plug before any ad-
justments, maintenance or repair.
Danger of electric shock.