Safety Guidelines For Battery Chargers; Original Accessories/Auxiliary Equipment; Before Use; Charging The Battery Pack (See FIg. A) - Parkside PAT 20-Li A1 Traducción Del Manual De Instrucciones Original

■ Never use this tacker for fastening electri-
cal cables. It is not suitable for the installation
of electrical lines, can damage the insulation
of electrical cables and thus cause electrical
shocks and increase the risk of fire.

Safety guidelines for battery chargers

This appliance may be used by chil-
■
dren aged 8 years and above and
by persons with limited physical,
sensory or mental capabilities or
lack of experience and knowledge,
provided that they are under super-
vision or have been told how to use
the appliance safely and are aware
of the potential risks. Do not allow
children to use the appliance as a
toy. Cleaning and user maintenance
tasks may not be carried out by
children unless they are supervised.
The charger is suitable for
indoor use only.
WARNING!
If the connecting cable needs to
■
be replaced, this must be carried
out by the manufacturer or an
authorised representative in order
to avoid safety hazards.
Original accessories/auxiliary
equipment
■ Only use the accessories and additional
equipment that are specified in the oper-
ating instructions and compatible with the
appliance.
│ GB │ MT
■ 42

Before use

Charging the battery pack (see fig. A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C.
♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket.
The control LED
♦ The green LED indicates that the charging
process is complete and the battery pack
is ready.
ATTENTION!
♦ If the red control LED
that the battery pack
cannot be charged.
♦ If the red and green control LEDs
flash, this means that the battery pack
defective.
♦ Push the battery pack
♦ Switch off the charger for at least 15 minutes
between successive charging sessions.
Also disconnect the power plug from the mains
power socket.
to the high-speed
(see fig. A).
lights up red.
flashes, this means
has overheated and
both
into the appliance.
PAT 20-Li A1
is