Overview; Technical Data - Resol AM1 Instrucciones

AM1 alarm module

Overview

64,07 mm
34 mm
40 mm
67,79 mm
• Reliable failure signal by LED
• Connection to a Building Management System (BMS) possible
• Supply and control via RESOL VBus
• Sturdy and weatherproof housing in shapely design
• Simple installation
AM1 alarm module
The AM1 alarm module is designed to signal system failures. It is to be connected
to the VBus of the controller and issues an optical signal via a red LED if a fai-
®
lure has occurred. The AM1 also has a potential-free relay output, which can e. g.
be connected to a building management system (BMS). Thus, a collective error
message can be issued in the case of a system failure.
Depending on the controller and the sensors connected, different fault conditions
can be signalled, e. g. sensor failures, excess or negative system pressure as well
as errors in the flow rate, such as a dry run of the pump. The AM1 alarm module
ensures that occurring failures can be immediately recognised and repaired, even if
the system and the controller are difficult to access or located in a remote place.
Thus, the reliability and the stable yield of the system are ensured.

Technical data

Housing: Plastic
Upper part of the housing:
PC 2207 UV
Base part of the housing:
Karilen E 42 D - H201
Protection type: IP 54
Ambient temperature: -25 ... +70 °C
(-13 ... +158 °F)
Dimensions: 111 × 68 × 40 mm
Mounting: Wall mounting
Display: 1 LED
Power supply: via RESOL VBus
Interface: RESOL VBus
®
Output: 1 potential-free relay
Switching capacity:
30 VDC, 1 A;
125 VAC, 0,5 A
The AM1 can be connected to all RESOL devices equipped with a VBus
The following devices will only work properly with the AM1 from the denoted
software version on:
• DeltaSol C from software version 1.03
®
ES from software version 1.15
• DeltaSol ®
®
Included
• AM1 alarm module
•
accessory bag with
2 × screws and wall plugs for wall
mounting
1 × terminal block
®
:
®
9
|