Storage Lock; Transportation; Energy Saving Tips; Extended Storage - Furrion Arctic FCR10DCDTA Serie Manual De Instrucciones

4. Repeat steps 2 and 3 to loosen the shelf fixing screw on
the other side. Pull to remove the shelf out from its original
position. (Fig. 20)
Fig. 20
5. Slide the shelf into an appropriate position and fix with
screw. (Fig. 21)
Fig. 21
Repeat the process for shelving in the refrigerator.

Storage Lock

Utilize the Storage Lock, provided in the accessories
package with the unit, to prop the door open during extended
storage. This will provide air flow throughout to reduce
moisture and odors.
NOTE: It is not recommended to leave the Storage Lock in
position during traveling, vibration may shake the latch loose.
1. Press the Storage Lock onto the lock bracket directly to
install it.
2. Press both sides of the Storage Lock as per the arrows
shown in Fig. 22 and pull to remove the Storage Lock.
Lock Bracket
Storage Lock
Fig. 22
12
3. Close the doors so that the door latch engages with the
storage lock.

Transportation

Your refrigerator is designed to operate during normal
transportation of your coach. Please refer to the following
guidelines to assist during transportation.
● During long trips, leave your refrigerator off until 3 hours
before your destination arrival. This will help reduce
any moisture/ice accumulation and accidental battery
discharging.
● Avoid traveling with food in the cavity. Wait until you have
arrived to your destination and remove any remaining
food before departing.
● Never transport with the Storage lock in place.
● Turn refrigerator to "OFF" if climbing/crawling any off-road
grades. Compressor oil should resettle within 2 hours.

Energy Saving Tips

● When possible, place your coach or refrigeration in a
position to avoid direct sun.
● Cool down the hot food to normal temperature before
putting them into the refrigerator.
● Be sure to wrap foods properly, and wipe containers dry
before placing them in the refrigerator. This could prevent
frost buildup inside the refrigerator.
● Organize and label the food to reduce door openings and
long time searches.

Extended Storage

Any time the unit is not to be in-use, it is considered
"extended storage". Follow the below steps to properly
prepare the unit for storage:
1. Remove all food and turn the dial to off.
2. Let any accumulated ice thaw, and dry out with a towel.
3. Disconnect power(either via main disconnect switch, and
turning the converter off or fuse).
4. Remove charcoal filter to preserve charcoal activation,
replace with a new filter every season or after three
months of active use.
5. Install door Storage Lock.
See the "Storage Lock" section about how to install the
Storage Lock.