Publicidad
Idiomas disponibles
Idiomas disponibles
SPECTRE Access UHF
Read only & osdp
Installation procedure
SPECTRE Module Access - SMA
Frequency Band
865 - 868 MHz
902 - 928 MHz
Morocco
867.7-867.9 MHz
Peru
916-928 MHz
Use an AC/DC power supply LPS type, Limited Power Source (as per IEC EN 60950-1 Ed2) or ES1 type, PS1 (as per IEC EN 62368-1) for main supply and for
an eventual V+/V-.
Main power supply:
Range +9 Vdc up to +36 Vdc
Consumption:
Typical: 1A under +12 Vdc
Communication:
RS485 (L+ & L-) / RS232 (TD & RD) / TTL (Wiegand / Clock & Data)
Pin out:
Removable connectors 3x4 pins and 1x8 pins, thread 3.81 mm / 0.149 in
Temperature:
-25 to +60 °C / -13 to +140 °F
Protection:
IP66 level
Chip:
EPC1 Gen2 (ISO 18000-63) - 1 to 62 bytes max
I/O:
4 optocoupled inputs and 4 optocoupled outputs
Module LED:
1 red LED: presence of power supply and 1 green LED: activity on Reader / host link
Antenna LED:
7 configurable colors (red, green, blue, orange, purple, turquoise, white)
RS485:
Use a multi-conductor shielded twisted pair cable. Max lenght 3 280 ft / 1000 m at 9600 baud.
RS232:
Max length 49.21 ft / 15 m.
Wiegand / Clock & Data: Use a multi-conductor shielded untwisted
2 cable AWG24 – 30 m / 98.4 ft max
2 cable AWG20 – 50 m / 164. ft max
▪ Install the module/reader away from computer transmission cables or from power sources (ex: RJ45, sector...).
The disruptions that they can cause can vary according to their radiation power and their proximity.
▪ Use a filtered and regulated power supply.
▪ Antennas connected to different modules/readers may interfere with each other. Move them away from each other.
▪ A power supply which provides 1.5 A min under +12Vdc is recommended.
If the IN/OUT are powered by the module, use a 2A min under +12Vdc power supply.
▪ Users must not remain within a range of less than, 34 cm / 13.39 in from an antenna for an extended period of time as per EN50364 applicable to this
type of device.
▪ Apart from the hatch the module housings must not be opened.
▪ Before any service operation you must de-energize reader.
▪ Check that the hatch seal is correctly positioned before closing.
▪ Do not remove the caps of unused
cable glands:
In order to access the module/reader connectors, open
the hatch.
UHF SPECTRE Access
Lecture seule & osdp
Notice d'installation
References
SMA-R41-A-U04-xx: TTL
SMA-R42-A-U04-5AB: RS232
SMA-R43-A-U04-7AB: RS485
SMA-W43-A-U04-7OS: osdp
SMA-R51-A-U04-xx: TTL
SMA-R52-A-U04-5AB: RS232
SMA-R53-A-U04-7AB: RS485
SMA-W53-A-U04-7OS: osdp
SMA-R41-A-U04-xx1M: TTL
SMA-R42-A-U04-5AB1M: RS232
SMA-R43-A-U04-7AB1M: RS485
SMA-W43-A-U04-7OS1M: osdp
SMA-R51-A-U04-xx1PE: TTL
SMA-R52-A-U04-5AB1PE: RS232
SMA-R53-A-U04-7AB1PE: RS485
SMA-W53-A-U04-7OS1PE: osdp
Power Supply Characteristics - SMA /SLA
Typical: 12 Vdc
Max: 1.5A under +12 Vdc
Recommended Cables - SMA / SLA
Recommendations - SMA / SLA
▪ Do not remove the caps from the unused
RF connectors:
Host Connection Access - SMA / SLA
only
the hatch provided for this purpose by unscrewing the 4 captive screws without removing them from
© STid - 20 PA des Pradeaux FR13850 Gréasque - NI1127X05 - Page 1 sur 18 - Ed. 02/10/2020
Frequency Band
865 - 868 MHz
ERP: 2W
902 - 928 MHz
EIRP: 4W
Morocco
867.7-867.9 MHz
ERP: 0.5W
Peru
916 - 928 MHz
EIRP: 4W
Characteristics - SMA / SLA
4 cables AWG24 – 60 m / 196.9 ft max
4 cables AWG20 – 100 m / 328.1 ft max
UHF SPECTRE Access
Solo lectura & osdp
Manual de instalación
SPECTRE Reader Access - SLA
SLA-R41-A-U04-xx: TTL
SLA-R42-A-U04-5AB: RS232
SLA-R43-A-U04-7AB: RS485
SLA-W43-A-U04-7OS: osdp
SLA-R51-A-U04-xx: TTL
SLA-R52-A-U04-5AB: RS232
SLA-R53-A-U04-7AB: RS485
SLA-W53-A-U04-7OS: osdp
SLA-R41-A-U04-xxM: TTL
SLA-R42-A-U04-5ABM: RS232
SLA-R43-A-U04-7ABM: RS485
SLA-W53-A-U04-7OSM: osdp
SLA-R51-A-U04-xx1PE: TTL
SLA-R52-A-U04-5AB1PE: RS232
SLA-R53-A-U04-7AB1PE: RS485
SLA-W53-A-U04-7OS1PE: osdp
6 cables AWG24 – 100 m / 328.1 ft max
▪ Install the module/reader with the word UP
facing upwards so that the connectors are down:
US
FR
ES
References
Publicidad
