exis BE-100 Manual De Instrucciones página 5

All manuals and user guides at all-guides.com
Speci cacions
• Equipped with a high precision Strain Gauge sensor system.
• Capacity 180 Kilos ( 396 lb./28st )
• Division 100 g. ( 0.2 lb+/-)
• LCD Display
• Tap-on Switch
• Automa c Zero rese ng
• Automa c switch o
• Over load indicator
• Low ba ery indicator
Power Supply
• Lithium ba eries are included ( CR2032 ). Please remove the insula on sheet from the ba ery
contacts before using. Replace the ba eries when the low ba ery indicator shows.
Opera ng Instruc ons
• Step 1. Put the scale on a hard at surface(avoiding carpets or any so surfaces.)
• Step 2. Switch on the scales by with a slight tap on the glass pla orm near LCD display. Then wait a
few seconds,the "0.0" will be displayed
8
ª
Note: The scales will not work properly if you step on the scales before it shows .
8
If this happens please start from the beginning of step 2.
• Step 3. Gently step on the scale. Put your feet evenly on the scale without moving and wait whilst
the scale compute weight. Your correct weight will then be displayed in the following way: 80.3
Kg.
80.3
Automa c switch o
When you step o the scale, it will automa cally switch o . ( If no weigh ng is carried out while the zero
is being displayed, the scale will automa cally switch o a er approximately 6 seconds ).
Overload indiacator
When the scale is overloaded ( over 180 Kilos / 360 lb. ) the following will appear on the screen: ERR
Overload indicator
Cuando se sobrepasa la escala (más de 180 kilos / 360 lb. ) aparece en pantalla el siguiente texto: ERR
e
RR
1
0.0
kg
0.0
kg
80.3
kg