Functions/Features Description - Trueshopping SFHT00B2SA Manual Del Propietário

Always charge the battery in a temperature range of (32° to
o)
113°F) and discharge in a temperature range of (32° to
140°F).
The battery pack and charger will be warm during charging,
p)
this is normal.
Do not continue charging the battery if it does not recharge
q)
within the specified charging time. Doing so may cause the
battery to become hot, explode or ignite. The temperature
range over which the battery can be charged is 32°F to
113°F. Charging the battery at temperature outside this
range may cause severe damage to the battery or reduce the
battery life expectancy.

FUNCTIONS/FEATURES DESCRIPTION

Component list
1 . Rear Handle Trigger Switch
2 . Front Handle Bar Switch
3 . Front Handle
. 4 Lock Off Button
. 5 Guard
. 6 Blade
. 7 Battery Charger (not included)
. 8 Battery (not included)
Connecting and Removing Battery
To remove the battery pack from the tool firmly press the battery release
button at the back of the battery pack and slide the battery pack backward,
and then pull or lift the battery out of the tool.
To install the battery pack into the tool, align the rails of the battery pack
with the rails in the tool and push the battery into the housing. To connect
the battery, slide the battery pack fully forward.
Battery Charging
IMPORTANT Before plugging in the power supply from the
charger (7) always ensure that the plug is switched off at the
mains power.
IMPORTANT The battery will be fully charged after
approx. 2.5 hours: remove it from the charger after this
time. Do not leave a battery charging for longer than 24
hours.
IMPORTANT The battery will be fully charged after approx. 2.5
r) When the battery is worn out, insulate the terminals with
hours: remove it from the charger after this time. Do not leave a
adhesive tape or similar materials before disposal.
battery charging for longer than 24 hours
s) Do not dispose of a battery in a fire, or with household waste.
Return exhausted battery to your local recycling centre.
t) Immediately discontinue use of the battery if, while using,
charging or storing the battery, the battery emits an unusual
smell, feels hot, changes colour or shape, or appears abnormal in
any other way.
6
6
4
2
3
5
7
1. Connect the charger (7) to a mains
power outlet (120Vac). The Green light
will glow on POWER.
2. Insert the battery (8) into the charger.
3. The red indicator will glow on CHARGER
indicating power on charge
4. When the battery is fully charged, the
green light on CHARGER will glow.
Note: You do not have to wait for a full charge
of the battery to use it on the tool. The battery
may be used on the tool as long as there is some
charge in the battery.
1
8