Change Of Door Opening Direction - Electrolux AEG S 70170 TK38 Libro De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

The refrigerator is designed to operate when it is totally
pushed to the wall.
When placing the refrigerator keep minimal
distances recommended in figure.
A : placing it under a wall-cupboard
B : placing it freely

Change of door opening direction

Should the setting-up place or handling demand it, door-
opening direction can be refitted from right-handed to
left-handed.
Following operations are to be done on the basis of figures
and explanations:
Pull out the plug from the mains socket.
Tilt back the appliance carefully being careful so that
the compressor can not touch the floor. It is
recommended to ask another person for help, who can
keep the appliance at this position safely.
Unscrew the adjustable feet situated on both sides (2
pieces), in addition the screws fixing the lower door
holders (2 pieces) respectively the screw on the other
side.
Take off the freezer door by pulling it slightly
downwards.
Unscrew the top door hinge pin of the refrigerator
then screw it back on the other side.
Fit the freezer door on the upper door hinge pin.
Put over the pin in the lower door holding plate in the
direction of the arrow.
Fix the plate on the other side leaving the position of
the door unchanged.
Then screw in the one screw in the place set free on
the other side as well as the adjustable feet (2
pieces) and set up the box.
Put over the handles on the other side and put the
plastic covering nails supplied in the plastic bag of
this instruction book into the holes set free.
Put the appliance to its place, set it level and plug it
into the mains socket.
In case you do not want to perform the procedures above,
call the nearest brand-mark service. Technicians will
accomplish the refitting expertly for charge.
GB
41

Publicidad

Tabla de contenido
loading

Tabla de contenido