Depth Stop - Ryobi RE180PL1 Manual Del Operador

 Make sure the hex nuts are securely tightened against
each other.
 Rotate depth stop to desired position, loosen lock knob
and adjust stop bar until it touches depth stop.
 Slide zero reset indicator up or down the scale on stop bar
until red line on zero reset indicator aligns with a desired
reference point. For example, align red line with 1 in. mark
on the scale.
 Lift stop bar to obtain desired depth of cut. For example,
if setting 1/8 in. depth of cut, the zero reset indicator will
move 1/8 in. from the 1 in. reference point.
 Tighten lock knob securely.
 Position the router so that the bit can extend below the
subbase for desired depth setting.
 Unlock plunge lock lever.
 Grasp handles and lower router until stop bar contacts

depth stop.

 Lock plunge lock lever to position bit at desired depth of
cut.
ZERO RESET INDICATOR
See Figure 6.
The zero reset indicator allows you to use the scale provided
on the housing to make quick depth of cut changes to existing
depth of cut settings. Simply choose a reference point on the
scale and slide the zero reset indicator up or down the scale
the distance required for new depth of cut. Then change stop
bar position by loosening lock knob and adjusting stop bar
until red line on zero reset indicator moves back to reference
point. Tighten lock knob securely to lock stop bar in new
position. The bit position will now increase or decrease the
exact distance the stop bar was adjusted.
NOTE: Each mark on the inch scale indicates 1/16 in.
ACCU-STOP™ MICRO-ADJUSTABLE
DEPTH STOP
See Figures 7 - 8.
The Accu-Stop™ Micro-Adjustable Depth Stop is located
on the base of your router and makes it possible to make
deep or heavy cuts in successive passes. Alignment marks
make depth of cut changes quick and easy.
A preset cutting depth is achieved by plunging router until
stop bar comes in contact with depth stop. The micro-
adjusting feature provides alignment marks at each 90° rota-
tion of the depth stop knob. Each 90° rotation of the knob
changes depth of cut setting 1/64 in.
A complete 360° rotation of the knob changes the depth of
cut setting 1/16 in.
The Accu-Stop™ Micro-Adjustable Depth Stop provides for
depth of cut changes to be made from 0 to 1/2 in. from the
initial setting of the stop bar. This initial setting of the stop
bar can be "zero" depth of cut, or it can be any depth of cut
setting that you choose as a starting point for a particular
job to be performed.
OPERATION
ZERO RESET
INDICATOR
WITH RED LINE
ZERO RESET INDICATOR
MICRO-ADJUSTABLE DEPTH
ACCU-STOP
12
SCALE
WITH RED LINE
LOCK
KNOB
STOP
BAR
ACCU-STOP
TM
STOP
MICRO-ADJUSTABLE DEPTH STOP
TM
EACH COMPLETE 360° ROTATION
OF DEPTH STOP KNOB
EQUALS 1/16 in. CHANGE IN
EACH 90°
ROTATION
EQUALS 1/64
in. CHANGE IN
DEPTH OF CUT
Fig. 6
Fig. 7
DEPTH OF CUT
Fig. 8