Set Instructions; Maintenance; Troubleshooting - Aqua One Infinity AP-150R Manual Del Usuario

GB
Setup Instructions
Decide where you are going to position the air pump.
1.
Remember the pump must remain accessible for

maintenance.

2. Where possible place the pump above the
aquarium. Avoid placing the pump on a carpeted
surface.
3. If not possible then ensure that a check valve
(sold separately) is fitted to the airline. It is best to
position the check valve as close to the aquarium
as possible.
4. Attach one end of the air line into your ornament
or air stone
5. Attach the other end of the airline into the air outlet
of your pump.
Position your pump. Ensure it is not going to vibrate
6.
off whatever surface you place it on.
Ensure your hands are dry, plug the pump in and
7.
turn on. Remember to arrange a drip loop.
Maintenance
Air stone
•
Replace the air stone every 6 months or when it
shows signs of deterioration.
• If being used in salt water a plastic or ceramic air
stone is recommended.
Diaphragm
• If pump is producing a lot of noise or the flow rate
has reduced this may be an indication that the
diaphragm assembly needs to be replaced.
• Look for any tear or damage on the diaphragm.
• To replace diaphragm assembly follow the
instructions below.
AP-150R & AP-250
1. Remove the 2 screws located in the back of the
Pump.
2. Lift top cover to reveal internals of pump.
To remove diaphragm from assembly - Peel
3.
diaphragm off the air outlet unit
To replace diaphragm remove screw on the
4.
diaphragm anchor
To replace flapper valve pull air chamber assembly
5.
up to remove from unit
Remove flapper valve cover. Do this to both sides.
6.
Replace flapper valve.
7.
8. Then reassemble unit.
AP-750 & AP-950
1. Remove the 4 screws located in the back of the
Pump.
2. Lift and turn top cover over to reveal internals of
pump.
To remove diaphragm from assembly - Peel
3.
diaphragm off the air outlet unit
Then pull the diaphragm anchor upwards to
4.
remove
To replace diaphragm remove screw on the
5.
diaphragm anchor
To replace flapper valve assembly remove air outlet
6.
manifold screw (on the side of pump) to completely
remove the air outlet unit
Remove flapper valve cover the flapper valve. Do
7.
this to both sides.
Replace flapper valve.
8.
9. Then reassemble unit

Troubleshooting

PUMP DOES NOT WORK
1. Ensure the plug is inserted correctly and the switch
is in the on position
THE MOTOR IS WORKING, BUT THERE IS NO AIR
COMING OUT OF THE PUMP
1. Check that the Air Line is not kinked
2. Check the Air Stone and replace if needed.
3. There is a rubber diaphragm inside the pump which
may have warn out and may require replacing. Consult
your Aqua One retailer.
4. The Flapper valves in the pump may have become
dirty or brittle and require replacing. Consult your Aqua
One retailer.
5. Turn the pump up (all models except AP-150R).
THE PUMP IS VERY NOISY
1. Check that the Air Line is not kinked
2. Check the Air Stone and replace if needed.
3. There is a rubber diaphragm inside the pump which
may have warn out and may require replacing.
4. There may be to much back pressure on the pump.
(It is to small for your application)
6