Installation Procedures; Unit Removal - Sanyo FXD-770GD Libro De Instrucciones

2. INSTALLATION PROCEDURES

MOUNTING STRAP USE
Mounting Strap
FIRE WALL
DASH BOARD
OR CONSOLE Mounting
Bracket
When mounting the unit into a DIN–standard cutout (182 × 53 mm) in the dashboard or console, attach the
provided Removable Trim Ring to the unit.
Insert the mounting bracket into the DIN-standard cutout (182 × 53 mm) in the dashboard or console.
1.
2.
Bend the mounting bracket stopper outward until the bracket fits snugly in the cutout.
Mounting Strap Use
3.
Attaching the Mounting Strap to the underside of the dash board, using screw. Attach the back of the
unit to the Mounting Strap using support stem bolt and hardware.
Bushing Use
3.
As shown in the figure above, securely fasten the screw, which has been inserted into the bush, to the
rear of the unit.

UNIT REMOVAL

GB
1.
Insert the unlock levers into the slots on each side of the unit until they click into place.
E
2.
Pull the levers to remove the unit.
Notes
• Handle the unlock levers carefully to avoid injuring your fingers.
F
• Keep the unlock levers in a safe place for future use.
D
FXD-770GD_Ebody(P01-18)
Removable
Trim Ring
16
16
BUSHING USE
Screw
Bushing
3/7/01, 5:57 PM