Cleaning And Maintenance - Amitek VC501 Manual De Instalación, Uso Y Manutención

GB
Before starting any operation read this manual and keep it for further consultation.
The manufacturer declines any and every responsibility if the suggestions brought in this manual are not strictly
observed.
WARNINGS
- Do not use the grill with wet hands, and wet/bare feet
- Place the grill at 3 cms minimum from walls or furniture, being sure that the same are not flammable
- Do not use electrical prolong wires without being sure of the load to bear in W.
- Do not pull the cable to disconnect the grill
- Do not leave the grill to atmospherically agents (sun, rain etc)
- Do not leave the grill within children range
- Do not plug in multiple sockets.
1) INSTRUCTIONS OF INSTALLATION
The installation operations must be carried out by qualified personnel and must be according to
the existing norms.
Once the appliance has been removed from packing, peel off the adhesive protection plastic film. The glue
residual must be removed accurately (do not use abrasive products).
Verify that the appliance is perfectly levelled on the base.
The appliance is set for a.c. operation at the power corresponding to the data brought on the technical
plate.
The earth conductor cable is marked by green/yellow colours.
The manufacturer declines every responsibility if the above accident preventions are not
respected.
2) INSTRUCTIONS FOR USE
Heating is obtained by heating element working with a thermostat for temperature regulation. To switch on
the warm show-case it is necessary to push the main switch and to rotate the knob clockwise on the desired
position (30-90°). A warning lamp shows that the appliance is working. During normal working this lamp will
lights on till the desired temperature is reached. After that it will lights off.

3) CLEANING AND MAINTENANCE

ATTENTION
Before cleaning and maintenance operations, the appliance must be disconnected and cold.
Be sure that the sponge in the drawer is always drenched with water as to obtain a Hot/Humid heating.
The stainless steel parts must be treated with non abrasive detergents.
We do not recommend any type of washing powder.