Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
If LED is...
Transmitter...
...lighting green:
...is connected to AC power and audio source, switched ON, and
receives signal. Headphones are not on the transmitter, charging
function is off.
...lighting orange:
...is connected to AC and audio source, switched ON, and receives
signal. Headphones are on the transmitter, charging function is on.
...lighting red:
...has detected no signal for several minutes, headphones are on
the transmitter, charging function is on.
...dark:
...has detected no signal for several minutes, headphones are not
on the transmitter, charging function is off, OR
...is not connected to AC power or switched OFF.
1.
Operating switches on or connecting the transmitter to your audio source may cause
clicks which at high volume settings may affect your hearing. Therefore, be sure to set
the VOLUME control on the headphones to minimum before switching between
different sources (tuner, turntable, CD player, etc.) or connecting the transmitter.
2.
Listening over headphones at high volume levels, particularly over extended periods of
time, may damage your hearing.
3.
Your HEARO 888 TITAN is a radio frequency device that conforms to the strict
European and FCC standards. For physical reasons that are not related to the quality
of the product, extremely strong interference sources may affect reception. In order to
maintain interference-free listening pleasure, do not operate your HEARO 888 TITAN
in the close vicinity of radio equipment, cellular telephones, or directly above TV or
computer monitor picture tubes. The supplied connecting cables are long enough to
allow the transmitter to be placed at a safe distance from interference sources.
Interference caused by other users of the 914, 434, or 864 MHz LPD band are beyond
AKG's control.
We recommend to clean the transmitter and headphones surfaces using a soft cloth
moistened with water.
Symptom
No sound.
CHARGE LED does not light.
Possible Cause
1.
AC adapter is not connected to
transmitter and/or AC outlet.
2.
Transmitter is OFF or not connected
to audio source.
3.
Connected audio source is switch-
ed off.
4.
Volume control on audio source is
set too low.
5.
Batteries are low.
6.
Headphones are switched off.
7.
Volume control on headphones/
transmitter is at zero.
1.
Transmitter is not connected to AC
power.
2.
Batteries are not correctly aligned
with polarity marks.
3.
Headphones are incorrectly posi-
tioned on transmitter.
4.
Headphones are ON.
4 Operation
4.6 CHARGE LED Status
4.7 Important Notes
5 Cleaning
6 Troubleshooting
1.
Connect AC adapter to transmitter
and/or AC outlet.
2.
Switch transmitter on or connect to
audio source.
3.
Switch audio source on to feed
signal to transmitter input.
4.
Increase audio source volume to
the point that transmitter switches
back on.
5.
Charge batteries.
6.
Switch headphones on.
7.
Set volume control to desired level.
1.
Connect transmitter to AC power.
2.
Check orientation of batteries in
battery compartment.
3.
Place headphones on transmitter
correctly.
4.
Switch headphones OFF.
Remedy
17
Publicidad
Capítulos
Tabla de contenido
