Best KEX8087 Manual Del Usuario página 10

PREPARE THE HOOD
Note: On stainless steel hoods, carefully
remove the plastic protective film from all
exterior surfaces of the hood and decorative
flues, prior to final installation.
1. Locate (2) tabs on top of the hood and inside
the round discharge opening. Fig. 5
2. Fold both tabs up 90 degrees. Fig. 5
3. Install the discharge collar inside the tabs
and secure with (2) 3.9 x 9.5mm screws.
Fig. 5
4. Attach an adequate length of 8" round steel
ducting to the range hood's discharge collar.
Fig. 5
5. Duct tape all joints to make them secure
and air tight.
INSTALL THE HOOD
1. Install the hood into its mounted position.
2. Align the rectangular opening on the back
of the hood with the wall-mounting bracket.
Gently lower the hood until it securely
engages the bracket. Fig. 6
3. Level the hood and secure with (4) mounting
screws (4.8x38mm). Use drywall anchors
provided if wall studs or framing are not
available. Fig. 6
8" DUCT
TABS
RECTANGULAR
CUTOUT
MOUNTING
SCREWS
(4.8x38)
- 10 -
DISCHARGE
COLLAR
FIG. 5
MOUNTING
BRACKET
FIG.6