Publicidad
Idiomas disponibles
Idiomas disponibles
• Fixture should be installed by persons with experience in household wiring or
by a qualified electrician. The electrical system, and the method of electrically
connecting the fixture to it, must be in accordance with the National Electrical
Code and building codes.
CAUTION: Always turn off power at fuse box or circuit breaker before
Installation instructions
removing or installing any light fixture.
Step 1: This mounting plate has been designed to work with a variety of different
junction boxes. Line up the knockout holes in the mounting plate with
the screw locations in your junction box. Drill out the matching holes
in the mounting plate using an electric drill and a 1/8˝ drill bit or knock
out the holes with a punch and hammer.
Step 2: Take the gasket included with this mounting plate and position it
behind the mounting plate. Line up the screws in the mounting plate
with the appropriate hole pattern in the gasket and remove gasket
material in those holes.
Step 3: Connect lampholder wires to supply wires from house (white to white
and black to black) using wire connectors (not included).
Step 4: Attach the mounting plate to your junction box using the screws
included with your junction box, making sure that the gasket is properly
aligned and that all screws are tightly secured. To prevent moisture
from entering the junction box, apply a bead of silicone sealant around
the edge of the mounting plate where it attaches to the junction box.
WARNING: Do not touch fixture during use as the fixture housing gets
extremely hot. Turn off fixture and allow to cool before replacing bulb.
Loosen the knob on the side of the light housing. Tilt fixture head up or down
Aiming the light
to desired position then retighten knob.
WARNING: Risk of fire/electric shock. Follow installation instructions
carefully.
SAVE THESE INSTRUCTIONS.
Call for customer service and/or missing or damaged parts (800-334-6871)
3
Publicidad
