Final Assembly - KlipXtreme KTM-352 Guia Del Usuario

Installation on concrete surface
5. Attaching the TV mounting arms to the back of the screen
1. Place your flat or curved panel TV side down on a soft, even surface, and identify the
threaded mounting points that are located on the back of the unit (VESA pattern).
2. Determine the correct screw size (M-A, M-B, M-C) by carefully measuring the depth of the
mounting point. Please note that not all the hardware included will be used.
3. Place the TV mounting arms on the back of the TV and line up the screw holes.
4. Insert a mounting screw into a washer and plastic spacer, and hand tighten them on to the
mounting arm. Be careful not to overtighten the screws.
CAUTION: Verify the adequate thread engagement of the screw/spacer combination on
your TV to avoid damaging the unit.
Note: Please note that flat washers are not necessary when using M8 screws (M-B, M-C).
5. Finish tighten the screws using a screwdriver. Repeat this step for the other mounting arm.

6. Final assembly

Note: Some flat or curved panels require two people to lift and position them onto the wall
plate, or dismount them from the wall.
1. Now the TV is ready to be mounted onto the wall plate. Make sure the mounting arms are
able to hook onto the mount. Next, pull the quick-release tabs to lock the mount into place.
The locking system ensures a quick and easy way to secure your TV to the mount.
2. You will be able to slide the mounting arms slightly to the left or right side of the wall plate,
in order to adjust your viewing angle, depending on the size of your TV and the space
available.