Operation And Configuration Precautions; Compliance With International Standards; Rf Interference; Noise - Digital Projection E-Vision Serie Información Importante

Digital Projection
E-Vision series

Operation and configuration precautions

Software update should NOT be carried out except by, or with the supervision of, Digital
Projection Service personnel.

Compliance with international standards

RF Interference

FCC
The Federal Communications Commission does not allow any modifications or changes to the unit
EXCEPT those specified by Digital Projection in this manual. Failure to comply with this government
regulation could void your right to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant with Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area may cause harmful interference, in which case the
user will be responsible for correcting any interference.

Noise

GSGV Acoustic Noise Information Ordinance
The sound pressure level is less than 39 dB (A) according to ISO 3744 or ISO 7779.

European Waste Electrical and Electronic Equipment (WEEE) Directive

Digital Projection Ltd is fully committed to minimising Waste Electrical and Electronic
Equipment. Our products are designed with reuse, recycling and recovery of all components
in mind. To this end, at end of life, your projector may be returned to Digital Projection Ltd or
its agent so that the environmental impact can be minimised.
Rev B August 2014
Important Information
Page 7