Royal KING S Generalidades - Advertencias - Instalación - Mantenimiento página 29

14.3 LIGHTING
• open the re door (Fig. 6.3.1);
• Clean the replace from any ash residues (Fig.
6.3.2);
• completely open the primary air adjuster (Fig. 6.3.3);
• carefully place the wood pieces inside the combustion
chamber;
• place a natural re starter on the stack;
• add some crossed ne wood sticks;
• light up the re starter from the top
• close the re door
• keep the air vent opened to ensure a high bright ame
• slightly close the air vent only when proper grill base
is ensured.
14.4 RELOADING THE FUEL
To load fuel inside the machine while it is running, follow
the procedure below:
• Open the re door slowly to prevent the creation of
an air gap inside the replace that would cause the
smoke to escape in the environment (based on the
draught of the fume exhaust duct).
• Reload the replace with fuel and then close the
re door.
amount of fuel.
The stove is provided with a bypass valve that favours
smoke transfer in the fume exhaust duct, minimizing the
smoke puffs in the environment.
14.5 ADJUSTING THE PRIMARY AIR
Primary combustion by placing air in the re box. This
is regulated by the register located on the front of the
ash box door (-6.4A-). If you wish to achieve more rapid
combustion, turn the knob so that the knob is completely
open; if instead you wish to achieve slower combustion,
turn the knob so that the knob is partially open; When
lighting for the rst time of the day or if the wood is damp,
it is advisable to keep the register fully open. Once the
re is burning it is advisable to adjust the air register
depending on how much heat is required or how long you
want the load of rewood to last. When the re has been
lighted up, the stove can work at the nominal charge and
the combustion air register can be turned off.
00 477 7010 - 08/2018 - PALAZZETTI - PN - Italy
2
1
29