Switch Off The Product; Frost Protection Function; Use The Heating Fan Only; Care And Cleaning - Silvercrest SOR 2400 D2 Instrucciones De Utilización Y De Seguridad

Press the heating fan switch
"I" to switch on the heating fan . An indicator
in the heating fan switch
air will be blown through the heating fan
To switch off the heating fan
heating fan switch
Using the temperature control
product to the desired temperature .
˜ Switch off the product
Press the heating fan switch
"0" to switch off the heating fan
Turn the temperature control
the heat level switch
Remove the mains plug from the mains
socket .
˜ Frost protection function
The frost protection function
automatically controls the product to
keep the room temperature above
7 °C, steps are as follows:
Connect the product to an earthed mains
socket protected by a residual current circuit
breaker .
Switch on the product by setting the heat
level switch to either "1", "2" or "3" and
2 ] [
by setting the temperature control
"MIN" . The product switches on when the
room temperature is approx . 7 °C . As soon
as the room temperature is above 7 °C, the
product automatically switches off again .
NOTE: The product will switch itself on and
off automatically to maintain a temperature
higher than 7 °C .
to position
4 ] [
will light up . Hot
4 ] [
, press the
5 ] [
to "0" position .
[ 4 ]
to set the
3 ] [
to position
[ 4 ]
.
5 ] [
to MIN and
3 ] [
to "0" .
2 ] [
to
[ 3 ]
˜ Use the heating fan only
To use the heating fan
product, steps are as follows.
.
5 ] [
Connect the product to an earthed mains
socket protected by a residual current circuit
breaker .
Press the heating fan switch
"I" to switch on the heating fan
indicator in the heating fan switch
light up . Hot air will be blown through the
heating fan
To switch off the heating fan
heating fan switch
NOTE: The heating fan works independently
from the power indicator
switch and temperature control
2 ] [
˜ Care and cleaning
m
WARNING! Let the product to cool down
before cleaning .
m
WARNING! Never immerse the product,
power cord or mains plug into water .
Remove the mains plug from the mains socket
and leave the product to cool completely
before cleaning .
Use a damp lint-free cloth to clean the
product . Use a mild detergent on the cloth
for stubborn dirt .
Do not use abrasive, aggressive or chemical
cleaning agents . It could damage the
surfaces of the product .
only on the
5 ] [
to position
4 ] [
[ 5 ]
4 ] [
.
[ 5 ]
, press the
5 ] [
to "0" position .
[ 4 ]
, heat level
[ 1 ]
GB/MT
. An
will
.
3 ] [
37