Duramaxx 10029779 Manual Del Usuario página 33

Software Upgrade
1. Copy the upgrade software files (3 files) into MicroSD Card; Note: Suggest to use 1
or 2 GB SD card to do the upgrade.
2. Insert MicroSD Card into camera;
3. Insert batteries or plug in USB power cable;
4. Press and hold Power/Navigation button, camera speaker emits one Beep Sound;
5. Release button when you see red indicator led flashes;
6. Then press and hold Menu/OK button; Note: red indicator LED stops flashing but
keeps lighting up;
7. Release button after you see until ISP interface shows up in screen
8. Upgrade succeeds when red indicator led is off;
9. Plug out batteries/or power cable;
10. Insert batteries or power cable; turn on camera. Done.
Note: Don't cut off power supply during software upgrade; otherwise, camera will not be able
to be turned on again unless software upgrade via PC.
USB Connection
When camera is connected via USB, press and hold POWER button, camera
speaker emits one Beep Sound, and red indicator LED lights up; then the
following interface appears:
Press POWER to choose DC in, or PC connection; press MENU to confirm choosing.
• DC in for Power Supply: Camera enters Test Mode Main Interface.
• PC Connection to Read MicroSD Card: Camera screen shows interface as below. Now
you can read MicroSD Card contents via PC. By pressing MENU again, camera will be
turned into a PC camera;
• Press MENU button again to Exit. Plug out power cable to turn off camera and restart.
33