Weidmuller DMS 3 Instrucciones De Servicio página 17

Ni-Mh Battery Pack
Note: When you charge the battery pack for the first time, or after
prolonged storage, charge it for about 24 hours to bring the battery up
to full capacity.
Battery charger
1. Plug the charger into the AC outlet.
Note: Sparks may be produced when the plug is inserted into the AC
power supply, but this is not a problem in terms of safety.
2. Slide the battery dock cover back to allow insertion of the Ni-Mh
battery pack.
• Verify that the cover is locked securely in place.
3. Insert the battery pack firmly into the charger.
To AC outlet
4. During charging, the charging lamp will be lit. When charging
is completed, an internal electronic switch will automatically be
triggered to prevent overcharging.
• Charging will not start if the battery pack is warm (for example,
immediately after heavy-duty operation). The orange standby
lamp will be flashing until the battery cools down. Charging will
then begin automatically.
5. When charging is completed, the charging lamp will start flashing
quickly in green color.
6. If the power lamp does not light immediately after the charger is
plugged in, or if after the standard charging time the charging lamp
does not flash quickly in green, consult an authorized dealer.
7. If a fully charged battery pack is inserted into the charger again, the
charging lamp lights up. After several minutes, the charging lamp
may flash quickly to indicate the charging is completed.
15