Assembly - Sears Craftsman 580.328300 Manual Del Propietário

Your generator requires some assembly and is ready
for use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of
your generator, please call the generator helpline
at 1-800-222-3136.
IMPORTANT: Any attempt to run the engine before it
has been serviced with the recommended oil will result
in an engine failure.
TO REMOVE THE GENERATOR
FROM CARTON
• Set the palleted carton on a rigid flat surface.
• Carefully cut bands around the shipping carton.
• Lift carton off the generator.
• Remove all packing material, carton fillers, etc.
• Remove the generator from the shipping pallet.
CARTON CONTENTS
Check all contents. If any parts are missing or
damaged, call the generator helpline at
1-800-222-3136. Contents Include:
• 10,000 Watt generator
• Owner's manual
• 2 Bottles of engine oil (28 oz.)
• 125 Volt, 30 Amp plug
• 125 Volt, 20 Amp plug
• 240 Volt, 30 Amp plug
• Oil fill spout
• Wheel kit

ASSEMBLY

CHECK BATTERY / ATTACH
NEGATIVE BATTERY WIRE
The battery on the generator is fully charged, sealed
and pre-installed except for the negative (black)
battery cable.
To install:
• Place key switch in "Stop" position.
• Remove nut on the negative battery terminal.
• Slide the negative battery cable over the screw on
the terminal.
• Reattach nut and tighten.
• Ensure the connections to the battery and
generator and tight and secure.
4