Setting Up Your Remote Control - IKEA ANSLUTA Manual Del Usuario

ENGLISH

SETTING UP YOUR REMOTE CONTROL:

Before you can use your remote control
you will need to complete a one-time set-up
process to pair the remote with the lights.
1. The UTRUSTA worktop light and the
ANSLUTA transformer are equipped with
a small sensor button. Press the sensor
once and it will light up.
2. Next press the remote control for a
blinking signal.
Repeat the same procedure for each
UTRUSTA worktop light unit and
ANSLUTA transformer installed.
3. The remote control is now set for
dimming or turning the lamps on and off.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
Technical Data
ANSLUTA remote control:
Frequency band: 2436.20 +/- 0.03 MHz
Operating frequency: 2436.20 MHz
Number of channels: 1
Transmit power: 2 mW
Mode of operation: Simplex
Complies with IDA Standards DA106634
This device complies with Part 15 of the
FCC Rules/Industry Canada licence-exempt
RSS standard(s). Operation is subject to the
following two conditions:
(1) this device may not cause harmful inter-
ference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation of the device.
WARNING:
Any changes or modifications to this unit
not expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
NOTE:
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation.
— This equipment generates, uses and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the quipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
— Reorient or relocate the receiving
antenna.
— Increase the separation between the
equipment and receiver.
— Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/
TV technician for help.
The crossed-out wheeled bin symbol
indicates that the item should be
disposed of separately from
household waste. The item should be
handed in for recycling in accordance with
local environmental regulations for waste
disposal. By separating a marked item from
household waste, you will help reduce the
volume of waste sent to incinerators or
land-fill and minimize any potential
negative impact on human health and the
environment. For more information, please
contact your IKEA store.
4