jbc ADVANCED JT 7000 Serie Manual De Instrucciones página 6

There are different models of protectors and
extractors as accessories.
The measurements of all the extractors and
protectors are given on page 47 of instructions
manual.
C) Tripod:
For small components for which an extractor
cannot be used, we recommend use of tripod 20
Ref. 0932050, as shown in the figure.
Use the tripod 40 Ref. 0932250 for larger integrated
circuits.
SOLDERING PROCEDURE
1 After desoldering the component, any solder
left on the printed circuit should be removed
using a desoldering station. We recommend
our desoldering stations AR 5800 and DS 5300.
2 Place the component or printed circuit.
3 When the component is correctly placed, solder
its pins.In the case of integrated circuits of the
Flat Pack type, first solder one pin of every IC
angle to fix it in place in the circuits.
4 Apply Flux FL 9582 ref. 0046565 in pads and
leads.
5 Solder the remaining pins. For that, we
recommend you use our soldering station, the
Advanced Series, which has 2 models of irons.
5
ENGLISH