Air Filter Service - MTD P65BOB Shown Manual Del Operador

Oil Service
• Check oil level regularly.
• Be sure correct oil level is maintained. Check every five
hours or daily before starting engine. See oil checking
procedure in the Operation section.
Oil Change
IMPORTANT: Be sure to check engine on a level surface with the
engine stopped. Drain the oil while the engine is still warm to
assure rapid and complete draining.
1. Remove all fuel from tank by running engine until it stops
from lack of fuel.
2. Remove drain plug and allow oil to drain into a suitable
container. See Fig. 6-1.
Oil Fill Cap
Drain
Plug
Drain Plug (If
Accessible)
Figure 6-1
WARNING:
Before tipping engine or equipment to
drain oil, drain fuel from tank by running engine
until fuel tank is empty.
3. Reinstall the drain plug and tighten it securely.
4. Refill with the recommended oil and check the oil level.
Refer to the Set-Up Section and follow the appropriate
instructions for a short or extended dipstick.
5. Reinstall the oil fill cap securely.
IMPORTANT: Used motor oil may cause skin cancer if repeatedly
left in contact with the skin for prolonged periods. Although this
is unlikely unless you handle used oil on a daily basis, it is still
advisable to thoroughly wash your hands with soap and water as
soon as possible after handling used oil.
NOTE: Please dispose of used motor oil in a manner that is
compatible with the environment. We suggest you take it in a
sealed container to your local service station for reclamation. Do
not throw it in the trash or pour it on the ground.

Air Filter Service

Paper filters cannot be cleaned and must be replaced once a year
or every 100 operating hours; more often if used in extremely
dusty conditions.
IMPORTANT: Never run the engine without the air filter. Rapid
engine wear will result.
NOTE: Your engine may be equipped with either a dual element
* Extended
rectangle paper filter with foam pre-filter or a single element
Dipstick Shown
oval foam filter. The dual element type has a long rectangular
shaped air filter cover with a thumb screw towards the rear of
the engine to access the air filter elements. The single element
type has a short rectangular shaped air filter cover with a primer
on the air filter base at the front of the engine. Follow the
appropriate instructions below for the engine on your unit.
Dual Element Air Filter
1.
Thumb
WARNING:
Never use gasoline or low flash point
solvents for cleaning the air filter element. A fire or
explosion could result.
Remove the thumb screw and the air filter cover. Remove
the foam and paper elements. See Fig. 6-2. Replace paper
element when dirty or damaged. Clean foam element or
replace when damaged.
Paper Element
Screw
Foam Element
Figure 6-2
s 6 — M
ectiOn aintenance
11