HYPPO
4.3: ELECTRIC CONNECTION: After cleaning the CONDENSATION WATER DISSIPATER following the
instructions in 4.2 (MAINTENANCE), connect the CONDENSATION WATER DISSIPATER back to the electric
circuit.
5: HOW TO INCREASE THE CAPACITY OF EVAPORATION
5.1: When the air conditioning equipment (for any motive described in the Point 2.1 or for being an air
conditioning equipment of major capacity) generates a major quantity of water, which originates dam of the
CONDENSATION WATER DISSIPATER, MAY BE INSTALLED 2 OR MORE CONDENSATION WATER
DISSIPATER'S UNITS, ONE LATER OF OTHER ONE, AND THUS IT IS POSSIBLE TO INCREASE
PROPORTIONALLY THE CAPACITY OF EVAPORATION. To achieve the aim, the water from the air
conditioning equipment will be canalized in 2 or more directions (one to every CONDENSATION WATER
DISSIPATER who has been connected). To such an effect there can be used accessories of the type
indicated in the GRAPH O and similar. Every CONDENSATION WATER DISSIPATER will establish itself and
works in independent form one of other one, and will evaporate water of agreement to the water quantity
that comes from the air-conditioning equipment. In these cases, of much of great volume of water produced
by air conditioned equipments, one recommends the installer to measure the volume of water previously
produced per hour by the air conditioned equipment and in this way it will be able to calculate the
CONDENSATION WATER DISSIPATER to install, considering that each CONDENSATION WATER DISSIPATER
has a capacity of evaporation of up to 1.5 lit / hour.
5.2: ELECTRICAL CONNECTION OF 2 OR MORE EQUIPMENTS: In case of having to install 2 or more
CONDENSATION WATER DISSIPATER, the electrical connections of every CONDENSATION WATER
DISSIPATER will be individual as it is indicated by the Point 3.3 (ELECTRIC CONNECTION). The assault of
cables of every CONDENSATION WATER DISSIPATER must be done to the ELECTRICAl CIRCUIT OF
FEEDING (13), in the same way that the GRAPH k. A scheme of installation of 2 equipments can observe in
the GRAPH p.
11