Temperature Settings; Time Settings - Rusk Engineering CURLFREAK IRECF1C Manual Del Usuario

OPERATING INSTRUCTIONS
the curl FreAK will create many different curl effects in the hair. it is easy to experiment
with the different settings to achieve your desired results.
Always ensure that the sections of hair you want to curl are no wider than 1 inch wide. the
type of curl will depend on the temperature selected and the timer setting, which dictates
the amount of time the hair is kept inside the curl chamber.

TEMPERATURE SETTINGS

there are 3 temperature settings to select from 375°F, 410°F and 450°F. We recommend
you always start with the lowest temperature setting and increase the level of heat as
required.
• Setting I (375°F) - for delicate, fine or colored hair
• Setting II (410°F) - for normal textured hair
• Setting III (450°F) - for thick or wavy hair

TIME SETTINGS

there are 3 time settings with an automatic beep indicator. these different settings will
give different curl effects. the longer the hair is held inside the curl chamber, the more
defined the curl will be. But results will also vary according to hair type. Use the following
as a guide:
• Setting 8 (8 seconds = 3 beeps) - for loose waves
• Setting 10 (10 seconds = 4 beeps) - for soft curls
• Setting 12 (12 seconds = 5 beeps) - for more defined curls
• At the end, there will be 4 quick beeps in succession to indicate time is up, and it's ready
to release hair.
AUDIO OFF SETTING
you can turn off the automatic beep indicator if it is not required by sliding the timer switch
to 0.
NOTE: When the 0 setting is selected, there will be no beep indicator to advise when to
release the styler. take extra care when using this setting.
CURL DIRECTION SETTING (Right/Left/Alternate)
Use the curl direction control to choose either a uniform or natural finish. Select the curl
direction by sliding the switch to either left (l) or right (r) or alternate (A).
(l) starts the curl to to the left, counterclockwise.
(r) starts the curl to the right, clockwise.
you can also select the opposite direction on each side to create a symmetrical look.
IRECF1C IB-13_157A.indd 8-9
When styling the left side of the hair, slide the curl direction switch to the left position (l).
When styling the right side of the hair, slide the switch to the right position (r). this ensures
that the curl sits toward the face on both sides of the head and will give a more uniform style.
For a more natural look, select the alternate setting (A). this will alternate the direction
after each curl.
INSTRUCTIONS FOR USE
• Ensure hair is dry and combed through.
• Plug the styler into a 125V outlet.
• Slide the temperature switch to the required heat setting.
• The styler is ready for use when the ON indicator light has stopped flashing.
• There are 3 time settings; choose the optimum setting
for your hair type. Alternatively, switch the time setting
to 0.
• Select the curl direction by sliding the control to either
position l, r or A.
• Separate a section of hair that is no wider than 1 inch
(Figure A). ensure that the section is clean, dry and
combed through.
• Please note the styler must be positioned into the hair
with the opening of the curl chamber facing toward
the head (Figure b).
• Position the styler where you want the curl to start.
the hair section must be straight, and placed neatly
through the center of the styler (Figures c and d).
• Once the hair is in place, let go of the hair section and
close the handle to allow the hair to be automatically
taken into the curl chamber (Figure e).
NOTE:
if you continue to hold the hair section after closing the handle the curl FreAK
will stop and beep to indicate that you must release the tension on the hair. if you have
taken too much hair, or hair is not neatly going through the center of the appliance, the
curl FreAK will again stop and beep to indicate a problem. this safety feature ensures
there will be no tangles.
• The hair is automatically drawn into the ceramic curl chamber where it is softly held and
heated from all directions to effortlessly form the curl.
• If you are using the timer setting, the automatic beep indicator will start as soon as the
A
B
C D
E
8/1/13 4:11 PM