Using The Remote Control; Frequently Asked Questions - Marmitek GIGAVIEW 821 Modo De Empleo

4.2 Using the Remote Control

4.3 LOOP-LINK FUNCTION
Activate/deactivate the loop-link function on the GV821 transmitter.
• Activate:
If the GV821 transmitter and receiver are both on, press the Power button once on the
receiver. The receiver will go to Stand-by mode and the transmitter will go to loop-link
function. The HDTV or projector connected to the receiver will then show the following
symbol for 3 seconds.
• Deactivate:
If the GV821 transmitter and receiver are both on, press once on the Power button on the
transmitter. Both the transmitter and receiver will go to Stand-by mode and the loop-link
function on the transmitter will switch off. The HDTV or projector connected to the receiver
will then show the following symbol for 3 seconds.

5. FREQUENTLY ASKED QUESTIONS

No connection
If the GigaView 821 cannot make a stable connection for 80 seconds during start-up, the
GV821 receiver is probably outside the range of the GV821 transmitter. Place them closer
together (a minimum distance of 2 metres apart) and check whether the connection can be
made.
GIGAVIEW 821 7