RCA ANT1100F Guia Del Usuario página 6

6
To remove the antenna (and mounting strips) from the
wall:
1. Hold the antenna against the wall gently to keep it in
place. DO NOT press the antenna against wall.
2. Find the tab for the single mounting strip at the bottom
of the antenna (on the metal part). Stretch the tab
straight down (away from the antenna) at least 12 inches
until the strip releases.
Important: NEVER pull the strip tab towards you.
3. Pull the antenna off the wall slightly so that you can
reach the tabs for the two mounting strips at the top of
the antenna. Repeat step 2 for each of these tabs as well.
Note: If you can't reach the tabs, you can remove the antenna
from the mounting strips using a piece of dental floss. Gently run
the floss behind the antenna, between the strips and the antenna,
until the strips separate. Then perform step 2 above for each of
the strips by themselves.
4. Remove the mounting strips from the antenna.
If you want to mount the antenna to the wall again, you
can find replacement strips at most retail or drug stores.
To mount the antenna using thumbtacks
(not included):
Insert two thumbtacks (not included) into
the two holes on the top of the antenna.
Hold the thumbtacks in place and lower the
holes onto the thumbtacks. Make sure to line
up the holes with the thumbtacks.