Elkay FS33-A Manual De Instalacion Y Uso página 4

1. Remove the faucet body (1) from the packaging, install
gasket onto the body, and insert into the a hole on the
sink or countertop.
NOTE: Required hole size I.D. 25-28mm
2. Mount the slotted washer (2) and spacer (3) onto the
inlet pipe (4) in the order shown and tighten them with
the locking nut (6).
NOTE: Do not over tighten locking nut. Damage can be
caused if excessive force is used.
3. Thread the quick connector (7) onto the inlet pipe (4)
and tighten the quick connector.
NOTE: The connector only should be tightened to prevent
leaks. Damage can be caused if excessive force
is used.
NOTE: Do not use PTFE tape or sealing compound on
the threads.
4. Insert PE tube into the quick connector (7) and connect
the other side of the PE tube to the filter outlet.
NOTE: Make sure the ends of the tube are clean and cut
straight.
5. After installation, confirm that all connections are tight
and secure. Turn the faucet to the off position and turn
on the cold water supply. Check for leaks.
NOTE: Handle up is off and down is on.
6. Open the faucet and allow water flow through to flush
any contaminants from the line. The faucet is now
ready to use.
NOTE: Flush for a minimum of one minute. Follow the
installation instructions for flushing the filter system.
• Faucet filter should be cleaned on a regular basis to maintain the bright surface.
• A soft cloth and clean water should be used to clean the faucet.
• The use of an abrasive cloth, sponge, or brushes can scratch the finish.
• Aggressive or acidic cleaners can damage the finish.
83
The Stainless Steel Dispensing Faucet FS33-A is warranted to be free from defects in materials and workmanship for
a period of one year from date of installation.
1000003974 (Rev. A - 05/17)
Installation
Faucet Maintenance
*
*
*
Warranty
International Customer Care | 630-575-4755 | IntlCare@elkay.com
1. Body
5. Gasket
Sink or Tabletop
2. Slotted Washer
6. Locking Nut
7. Quick Connector
283
*
206
4
4. Threaded
Inlet Pipe
3. Spacer
*
*