Publicidad
Idiomas disponibles
Idiomas disponibles
The gate can be heavy or light, rigid or flexible, wooden, iron, or plastic: the operator accepts and adapts to any of these situations, as long as
each leaf does not exceed 250Kgs of weight and 5Mts of length.
Before proceeding with installation, it is important to verify the gate's perfect rotation in the respective bolts and to verify its lubrication. This
operation is important for the operator's perfect functioning.
NOTE:
when installing the operator, you must fulfil with the inclination shown in
A
1.1 - Fix the support (big) to the pillar by the leaf's side according to
NOTE);
1.2 - Fix the operator with a screw to the support;
D
1.3 - Loose the rod until its course end;
D
1.4 - Tighten the rod a complete turn (360º);
B
1.5 - Fix the support (small) to the hole in the operator's terminal, and then fix it to the leaf. Keep in mind the final inclination (see above
NOTE);
1.6 - Repeat the previous enumerated instructions for the other leaf;
1.7 - Place mechanical jambs in both opening and shut (
When opening and closing the leaf, NEVER use the whole course: place a mechanical jamb in the opening and another at the shut, so that the
leaf stops before the course's end.
ATTENTION:
to block and unblock the leaves manually (deactivation and activation of the "endless"), turn the unlock device (
the supplied key.
If the pillar is made of iron, weld the plate as shown in
- Marks the holes of the plate;
- Drill 10mm diameter holes on the marks;
- Place M10 threads
- Fix with M10 steel screws
If the pillar is made of masonry (
- Mark the holes
- Drill 12mm diameter holes
- Insert the expansion "bushing" and fix
Once chosen the opening angle (95º-120º), follow the measures in
INSTALLATION: POSITIONING
INSTRUCTIONS OF OPERATOR'S INSTALLATION
A
Fig. 03
).
INSTALLATION: FIXING
Fig. 04
, or:
Fig. 05
), do the following:
QUOTAS TO RESPECT WHEN MOUNTING THE OPERATOR
Swing Gate Operator WING300/400/600
Fig. 02
: the reducer must be inclined about 1 degree.
Tab. 01
: quotas to respect. Keep in mind the final inclination (see above
Tab. 01
Fig. 06
(see also
) to fix the support.
C
Fig. 01
A
Pag. 07
English
), using
Publicidad
