Electrical Connections - Wiring Diagrams - Lamborghini Caloreclima Xilo 20 MC W TOP Manual Para La Instalación Y El Mantenimiento

ELECTRICAL CONNECTIONS - WIRING DIAGRAMS

The boiler must be connected to an earthed, single-phase 230V-50 Hz mains supply by means of a three-wire
cable, ensuring that connections to the LINE and NEUTRAL terminals are made correctly.
A bipolar switch must be used with contacts opening to at least 3 mm.
The power lead must only be replaced by another with the following characteristics: "HAR H05 VV-F" 3 X 1.00
mm 2 . (You are strongly advised to use original LAMBORGHINI accessories and spare parts only).
Installation must be made in compliance with safety REGULATIONS IN FORCE.
Make a good earth connection.
Voltage Frequency
V
230
To gain access to the electrical panel which houses the power supply terminal block and any connection to a
room thermostat, proceed as follows:
G Disconnect the boiler power
supply
G Undo the two grating screws
(fig. 1)
G Undo the two jacket fixing
screws (fig. 2)
G Raise the jacket and then pull it
towards you (fig. 3)
G To access electrical and
electronic parts loosen screws A
and pull the entire panel
outwards (fig.
downwards and undo the
screws B on the cover C
fig.3
Absorbed power
Hz MC
0,115
50
4). Tilt
fig.1
fig.4
A
kW
MCS
0,145
A
Protection Noise level
index
MC
IP
51
44
fig.2
fig.5
c
B
32
dB (A)
MCS
46