Honeywell QUICK HEAT HZ-614 Serie Manual Del Proprietário página 3

12. To disconnect the heater, first turn controls to the OFF position, then grip the plug and
pull it from the wall outlet. Never pull by the cord.
13. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as
this may cause an electric shock or fire, or damage the heater.
14. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not
use on soft surface, like a bed, where openings may become blocked.
15. A heater has hot and arcing or sparking parts inside. Do not use it in the areas
where gasoline, paint, or flammable liquids are used or stored.
16. Use this heater only as described in this manual. Any other use not recommended by
the manufacturer may cause fire, electric shock, or injury to persons.
17. Avoid the use of an extension cord because the extension cord may overheat and
cause a risk of fire. However, if you have to use an extension cord, the cord shall be
No. 14 AWG minimum size and rated not less than 1875 watts.
18. The output of this heater may vary and its temperature may become intense enough to
burn exposed skin. Use of this heater is not recommended for persons with reduced
sensitivity to heat or an inability to react to avoid burns.
SAVE THESE INSTRUCTIONS
19.
IMPORTANT SAFETY INSTRUCTIONS
REGARDING THE PLUG ON YOUR PRODUCT
Fig. 1
OPERATION
• Place the heater on a firm, level surface away from any
combustible material.
• With Power knob in the OFF position, plug the heater
into a grounded outlet.
• To turn the heater on, turn the Power knob clockwise to the
ON position. (Fig. 2).
• If you want to use the Quick Heat™ feature, turn the
Power knob to the Quick Heat™ Setting.
COVER OF
GROUNDED
OUTLET BOX
QUICK
HEAT
Fig. 2
off
on